With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Have you ever wanted to have a neon glow in the night will riding your ripstik? This instructable will show you how to install any number or color of...
For this mod you will need a few tools and some electrical supplies. Tools: Philips Screw driver Allen wrench for the bolts on the bottom of the rips...
Take every screw out of the bottom of your ripstik. 1. take it all apart 2.opened 3.opened.
Drill holes where the image notes point out. If I say "drill through the side." that means to drill through the wall with the note over it.
Since I am using Blue LEDs you need a 4.5 volt power supply. True Green and white would also use 4.5V i.e. 3 triple aaa If you use Green red yellow ...
You'll need to take it apart to do this, If it isn't already. after you follow the image not.s you gotta put the torsion bar back together. Be caref...
1.follow the notes. 2. Once you finish stripping all the wire it's time to connect the wires t the power supply and switch.
1.you need to "frost" the lLEDs before adding them by rubbing the led on sandpaper until it turns white allover, this will be the part of the step tha...
put all the screws back on and ride away!
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »