First instructable, please rate, all criticism accepted
Step 1: Tools needed
1. A hammer
2. A small screw diver
3. Exacto/Sammy knife (I don't really know the name)
BE CAREFUL NOT TO STRIP THE SCREWS! I did that with my first attempt and could never get the screw out.
Step 2: Disassembling the gun
There are 9 screws you really need to worry about, the screws on the gray compartment do not need to be taken out.
There are six screws on the outside the gun, and three behind the thing you pull back.
Like I said before, the four screws on the gray compartment do not need to be taken out.
Step 3: Taking Out the Air Restrictor
NOTE: DO NOT WHACK THE HAMMER TO THE SCREWDRIVER WHEN TAKING OUT THE A.R. IT WILL GO STRIGHT THROUGH THE BARREL, RUINING THE GUN!
Thank you atombomb1945 for bringing this to my attention.
Step 5: Demo
Compared to the original, this gun is louder and, by far, stronger.