This is an extremely easy modification on how to take the air restrictor out of a Nerf Eliminator gun.

First instructable, please rate, all criticism accepted

Step 1: Tools Needed

For this project you will need:

1. A hammer
2. A small screw diver
3. Exacto/Sammy knife (I don't really know the name)

BE CAREFUL NOT TO STRIP THE SCREWS! I did that with my first attempt and could never get the screw out.

Step 2: Disassembling the Gun

Unfortunately, I did not take any pictures of this step. Before taking out the screws you need to cut off the plastic cover at the bottom of the gun (see the first picture of the instructable [on the intro]).

There are 9 screws you really need to worry about, the screws on the gray compartment do not need to be taken out.

There are six screws on the outside the gun, and three behind the thing you pull back.

Like I said before, the four screws on the gray compartment do not need to be taken out.

Step 3: Taking Out the Air Restrictor

This step is very easy, once you have the barrel part out all you need to do is put the small screwdriver in the back and hammer out the air restrictor!

NOTE: DO NOT WHACK THE HAMMER TO THE SCREWDRIVER WHEN TAKING OUT THE A.R. IT WILL GO STRIGHT THROUGH THE BARREL, RUINING THE GUN!

Thank you atombomb1945 for bringing this to my attention.

I apologize to everyone who has this happen to them.

Step 4: Parts of the Barrel You Need/ Do Not Need

The title of the step is self explanatory

Step 5: Demo

Heres a video of the gun shooting without the air restrictor. When I shot this outside it went 60 feet!

Compared to the original, this gun is louder and, by far, stronger.