Nerf Gun Modification

Step 2 Assemble Brass Pieces

Piece together to brass pieces. Use the teflon tape for sealent. This is where the wrenches come in handy. You can look at the picture for help on the first page.

3/8" by 3/8" pipe to tube converter will screw onto the male end of the close nipple converter.On the other end of the close nipple converter, screw on the valve.Add the other close nipple converter on the second end of the valve. Now add the 3/8" to 1/2"piping converter on the close nipple converter. You are done with the brass.

Comments

[Spiderdog3000]

Does it have to be 3/8" can it be 1/2"?

[mettaurlover]

yes, actually, it does to fit inside the barrel. the othe way around would fit outside the barrel.

[Spiderdog3000]

If it's outside the barrel, does that make it better?

[mettaurlover]

no. in fact, that makes it worse because there will always be some air that leaks on a pipe that fits around the other one if said pipe is the source, while if said pipe is the destination it doesn't lower the pressure at all.

[Spiderdog3000]

Well it's a good thing I didn't do that.

[mettaurlover]

yep. anyway, gotta get back to work on my railgun minigun.