Step 1: Removing AR's
Step 2: Pistol Integration w/barrel addition
Again, much of what I did can be found online. Integrate the pistol component onto the location of the the bipod.
The Barrel component was added for the awesome factor. Simply cut about 6.25" from the muzzle (6" at minimum) and use the "front sight" from the pistol/barrel extension.
Step 3: Mag Mod Banana Style
The reinforcements I've seen online were with small strips of wood. I used the other feed ramp and cut it down into usable peices to add support. Also, I went ahead and split the mags completely inhalf in order to hot glue the inside as well as the outside for added support. Just make sure to hot glue the inside on the right spots or else the feed ramp wont glide so smooth. I used alot of electrical tape for the springs.
Step 4: ...and...yeah
Tools used (wouldnt you think that this would be placed in the beginning?) sharp cutting blade/dremel, philips screwdriver, pocket knife, hot glue gun, automotive silicone, masking tape, cutting/needle nose pliers, ruler, coat hanger, leatherman, and a funnel.