Nerf Vulcan Modification Project

Step 3: M1 P2

I used a drill bit and a knife to hollow out the tube, but anything that gets the job done should work.

This is a long and tedious mod, since it has to be repeated many times.

However, it's probably the easiest mod to do, since you don't have to disassemble the gun.

Comments

[melder3]

A much easier and cleaner way of doing this is to use a small pair of wire cutters and simply snip the pieces of plastic holding the pegs in place. Two quick snips on each peg and you are done. It took me less than 5 minutes to remove all of the ones from my belt.

[crazyboy007]

 you can also use needle nosed pliers to rip these out. its easier and doesnt hurt the sides.