Introduction: Nice Freaky Goggles for Halloween and Nice Party's
On the cheap,
1$ for the goggles(made in china),
an old nylon bag,
an swimming goggles head band,
Lots of cutting and drilling tools(Dremel, scissors, cutter, sandpaper, etc...),
some screws,
Glue
Patience for 4 to 6 hours.
Step 1:
Get those chineese soldering goggles for a dolar
Step 2:
Disassemble them
Step 3:
All of the parts
Step 4:
Now it's time to grab your dremel and start cutting all apart.
Step 5:
You should end up like that
Step 6:
Drill some attach points for the straps
Ok here is an option, up to you, but it looks kind of funny too, i drilled holes on the mount to place some screws(in my case 4), to swivel the fore mount.
It's a good moment to clean those cuts and prepare the frame to cover it with some nylon textile.
Step 7:
Glue the frames to the nylon, let them dry, and then cut the excess, so your face won´t be hurt using them
Step 8:
place the straps and figure out the right measure for your head on the nose strap, then glue it
Step 9:
Glue time, start to wrap every bit of the frames with nylon textile, it's a kind of tricky, but it's what it gives the "Pro" touch
Step 10:
Still have to clean some of the cut's, i used a lighter to smooth everything out, also drilled the lenses with tiny holes, i it's a good moment to draw a nice pattern for the holes on the lenses, mine were to fast to think about that!
Step 11:
Nylon covering complete!
Step 12:
And this is what you should get after all the work done!!! Nice halloween, Trance party's etc....
Participated in the
Halloween Props Contest