Print PDF
Favorite
Email
Step 8Glue stuff into place.
First glue the circuit board into place inside the owl with the hot glue gun.
Now glue the wires from the 9V battery plug to the side of the case. You should glue the wire as close to the board as possible. The point of this is to keep the wire from being ripped out of place on the board by putting all the strain on the spot at where it is glued to the casing.
Lastly, using epoxy, coat the bottom of the 9V battery clip very well and attach it to the inside of the case. Let it sit for a few hours.
Now glue the wires from the 9V battery plug to the side of the case. You should glue the wire as close to the board as possible. The point of this is to keep the wire from being ripped out of place on the board by putting all the strain on the spot at where it is glued to the casing.
Lastly, using epoxy, coat the bottom of the 9V battery clip very well and attach it to the inside of the case. Let it sit for a few hours.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
