Print PDF
Favorite
Email
Step 3Arduino Eject Test
Open the "NoKES_eject_test" sketch in the Arduino Program and upload it to I/O board
With the arduino powered off and the power disconnected from your cd-rom, connect your Opt-Isolator as shown below
connect your power supply to the cd-rom ensure that it opens and closes by pressing the eject button
power on the arduino and reset immediately
the arduino should blink a few times and the Cd Tray will eject on it's own.
With the arduino powered off and the power disconnected from your cd-rom, connect your Opt-Isolator as shown below
connect your power supply to the cd-rom ensure that it opens and closes by pressing the eject button
power on the arduino and reset immediately
the arduino should blink a few times and the Cd Tray will eject on it's own.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
