No Screws or Holes Pull Up Bar / Door Gym

Step 3 Construction

A couple of things to keep in mind before constructing this build is that it takes a lot of leverage to put these pieces together so using baby-oil or WD-40 or some other type of lubricant may be necessary. I also used a longer pipe to use a leverage while constructing the pull up bar, just be careful not to strip the threads.

1) I started with the two 4-way directional pieces. I started by fitting one of the closed nipples to the 4-way directional coupling and then attached a 45 degree coupling to that piece. Make sure to align the 45 degree appropriately. The pictures show better detail. (Picture 3)

2) Then I attached 6" nipples to the 45 degree sections. These will be the wide-grip handles. (Picture 4)

3) I took 3" nipples and attached it to the top of the four-directional couplings. Apply a 3-way directional coupling to the end of the 3" piece so the perpendicular feeder points outwards. Another 6" nipple will be installed here. (Pictures 5 and 6)

4) Then I took two of the 90 degree couplings and attached 5.5" nipples to them. (Pictures 7 and 8)

5) Taking the pieces from the above step I then attached 4" nipples with 90 degree couplings on top. (Picture 9)

6) I attached the pieces made in steps 4-5 to the pieces from steps 1-3. This finishes the majority of the project. (Picture 10)