Print PDF
Favorite
Email
Step 2Building
- Start by cutting your pvc to length.
- Using the painters tape, wrap a double wide strip all the way down in a spiral pattern.
- Spray paint with red, let dry then remove tape.
- Plug in your red and white rope light to soften them up. Attach one rope clip in the middle of each stripe in a line all the way down.
- Wrap the rope lights tightly around the pole inserting into the clips as you go. I covered the last few feet of rope light with black tape to hide it, but that is up to you.
- Cut a wood block about four inches long to fit inside the top of the pole. Screw through the pipe into the wood to hold it in place. This will give you a base to screw the light fixture onto.
- Splice and connect extension cord wires to your light and run it down through the pipe and out the bottom.(Be careful with hooking up electricity. If you don't know what you are doing call someone that does)
- Cut another wood block to fit in the bottom a few feet long. I used landscape timbers and they fit perfectly. Attach the two small brackets to the top and bottom of the wood to hold the rebar in place. You could also try to drill through the wood and put the bar in that, but whatever you do make sure it's strong.
- Using the painters tape, wrap a double wide strip all the way down in a spiral pattern.
- Spray paint with red, let dry then remove tape.
- Plug in your red and white rope light to soften them up. Attach one rope clip in the middle of each stripe in a line all the way down.
- Wrap the rope lights tightly around the pole inserting into the clips as you go. I covered the last few feet of rope light with black tape to hide it, but that is up to you.
- Cut a wood block about four inches long to fit inside the top of the pole. Screw through the pipe into the wood to hold it in place. This will give you a base to screw the light fixture onto.
- Splice and connect extension cord wires to your light and run it down through the pipe and out the bottom.(Be careful with hooking up electricity. If you don't know what you are doing call someone that does)
- Cut another wood block to fit in the bottom a few feet long. I used landscape timbers and they fit perfectly. Attach the two small brackets to the top and bottom of the wood to hold the rebar in place. You could also try to drill through the wood and put the bar in that, but whatever you do make sure it's strong.
| « Previous Step | Download PDFView All Steps | Next Step » |
http://www.lowes.com/pd_50364-1716-L5133738_0__?productId=3276621&Ntt=u+shaped+&pl=1¤tURL=/pl__0__s%3FNtt%3Du%2Bshaped%2B