Print PDF
Favorite
Email
Step 10Fixing it down
When you set your Booby Trap you are going to want to stop it moving about and remove the possibility of being pulled over by the Trip Wire.
To give you the ability to fixed down make 4 holes. Two on one side of the Bottle Top and two on the other. Then thread some string through the holes and tie a knot.
All you need do now in order to fix your Booby Trap in place is to either Sticky Tape the string down, or use the two Drawing Pins like in the picture below.
This also gives it the ability to be fixed vertically to a door frame etc.
To give you the ability to fixed down make 4 holes. Two on one side of the Bottle Top and two on the other. Then thread some string through the holes and tie a knot.
All you need do now in order to fix your Booby Trap in place is to either Sticky Tape the string down, or use the two Drawing Pins like in the picture below.
This also gives it the ability to be fixed vertically to a door frame etc.
| « Previous Step | Download PDFView All Steps | Next Step » |
3
comments
|
Add Comment
|
7
Jun 21, 2010. 9:54 PMMFPOSGBCS
says:
how do you put on the projectile???
Reply
Mar 9, 2010. 2:46 PMmechanical mayhem machine
says:
or duct tape it
Reply
3
Nov 9, 2009. 5:32 PMthe "wow shammy"
says:
you could just hot glue it and then if you wanted to move it you could rip it off and glue again. once the hot glue is every where you could just peel it off.
Reply
 |
Add Comment
|
