This year my wife expressed an interest in entering the contest so I designed a boat for her that is more stable than last years version.
I ran into some problems with my prototype. The design was good but I needed some extra screws in the bottom and I will explain that further in the instructable. There ended up being two slightly different versions of this design built.
Warning: Woodworking is inherently dangerous. You are using sharp tools some of them spinning at large RPM's. You need to be wearing eye protection at all times, hearing protection as needed and because you are going to be working on some very small pieces you must use a push stick. Niether I or Instructables bear any responsibility if you do something stupid, lose focus, act carelessly, or recklessly.
The same can be said about boating, you should be wearing a life vest anytime you are in a boat and always acting in a safe manner.
Please note that this design was inspired by the "one sheet wonders" group at Yahoo. For other great designs please stop and visit them. You may make and sell copies of this design but please give credit where it is due.
Step 1: Materials*
2) 2 8" 2x4's (As few knots and a straight as possible, Yeah, Yeah I know) If you are not entering a contest like I was you might want to get a knot free 1x4 for the chine logs.
3) 1 Roll of Duct tape. (Once again if you are not entering a contest like I did get yourself some waterproof adhesive, chaulk and maybe some fiberglass tape and resin for the seams.)
4) 1 Lbs of fasteners, I used about 1/2 lb of 1"x6 coarse thread drywall screws. I f you can get 3/4 inch that will be great for the Chines and Gunwales and Inwales (Pronoucned gunnel and innel).
5) You will also need a scrap piece of wood 32" x12" that you will use for a removable form
* same as First Instructable