Introduction: Organizer for Screws From Jars and Metal Cans

Few months ago I built an organizer for screws. To this day, I am

very happy with this organizer. This is a very simple construction,

but very useful and cheap to do.

This project can also be seen here: Cheap organizer for screws

Step 1: Drill a Hole in the Cans

I drill a hole in the can and screw the handle.

Step 2: Cutting, Drilling and Screwing

At first I cut down all the wooden elements. Then I drilled a hole under the screws.

Next I assembled all the pieces together.

Step 3: Mounting the Lid From the Jars

Two screws are the minimum for one lid. This makes the jar stable and easy to open.

Step 4: Making Can Holders

Step 5: Fitting Felt Pads

To protect against scratches I mounted four felt pads.

Step 6: Organizer Is Finished

Comments

About This Instructable

1,255views

36favorites

License:

Bio: Software, electronics, do-it-yourself
More by adachsoft:DIY USB Charger for Your Phone - LM2596DIY WIFI RC Car With ESP8266 and Arduino IDEControl Any Devices Using Raspberry PI and PCF8574, Relay Module
Add instructable to: