Introduction: Origami Boba Fett Finger Puppet#FerociousDougnuts

Picture of Origami Boba Fett Finger Puppet#FerociousDougnuts

I was experimenting with some star wars finger puppet folds when I stumbled upon this weird trick with an origami emergency Yoda from "Darth Paper Strikes Back". When I was finished I didn't know what i just did, then i discovered that it looked like Boba Fett. After that i colored it and decorated it. So this model is similar to making an emergency Yoda, except with a couple of tricky folds.

Step 1: Step 1: Get the Following Items

  1. Printer, or line paper (doesn't matter)
  2. colored pencils

Step 2: Step 2: the First Fold

Picture of Step 2: the First Fold

for the first fold, your going to want to get the right side of the paper, and fold it past the middle. Then do the same for the middle.

Step 3: Step 3: Corner Folding

Picture of Step 3: Corner Folding

Now flip the paper and fold the top corners like so.

Step 4: Step 4:

Picture of Step 4:

Fold down a few inches from the corners, but don't go too far, that;s important.

Step 5: Step 5:

Picture of Step 5:

Now fold it few inches to the top like so.

Step 6: Step 6:

Picture of Step 6:

Fold the bottom corners, then fold it back.

Step 7: Step 7:

Picture of Step 7:

Now fold down the bottom corners, to the line i'm pointing at.

Step 8: Step 8:

Picture of Step 8:

Now fold the top corners as shown here.

Step 9: Step 9: Styling Time!

Picture of Step 9: Styling Time!

Finally, color and decorate however you want.

Step 10: Step 10: Here Is Your Finished Product

Picture of Step 10: Here Is Your Finished Product


seamster (author)2015-05-26

Awesome, Boba Fett is the coolest!

Can you explain the hashtag in your title though? What's that about?

rasengan_12 (author)seamster2015-05-26

This was for a class project, so i put the # to show i did it.

About This Instructable




More by rasengan_12:Origami Boba Fett Finger Puppet#FerociousDougnuts
Add instructable to: