Introduction: Origami Skeleton Hand
Please vote for me!
Step 1: Square
Make an origami square and then fold in half from corner to corner.
Step 2: Base
Unfold the triangle and then fold other way. After that unfold and then fold down into a rectangle. Unfold.
Step 3: Base 2
Fold the paper like the picture.
Fold the triangle in half cemetricaly. Fold top to bottom on middle line. Unfold. Fold top to that line. Unfold. Fold bottom to middle line. Fold that down to bottom. Fold top to the centre and then fold tip up. Then turn over. Fold the bottom up and the top over to look like the picture. Then fold the top away and down. Unfold to triangle.
Step 5: Hand.
Fold the triangle almost cemetricaly so it is like the picture.Then fold up on the lines switching every one (turning it over and over again.)
Step 6: Fingers
Fold out the different pieces of paper and then put them in the right place. After you Finish that it depends which hand you want. (Right or left) you fold the fingers together to show which way you want them.
Step 7: Curves
You then add on some curves to make the hand look more natural.
Good job you finished!(if you have any questions just leave a comment and I will address it.)