Introduction: Ornate Coasters

Here I made six ornate coasters!

Step 1: Computer

Here is the file I made to make these ornate coasters. For the most part, the cutting and engraving are on the same separate layers. I have the rostering on define rent layers which allows the laser cut time shorter.

Step 2: Laser-Bed

Here I had to make sure the material in the bed was level and straight so the file did not cut off.

Comments

About This Instructable

942views

18favorites

License:

More by DamianS94:Aquarium StandOrnate CoastersEngraved Rock!
Add instructable to: