Well i made a Binder... its quite heavier than a regular binder, but its also stronger and looks kind of cool.
For this project i used the following materials
a Knife *
a "dremel tool"
a paintbrush (mainly for cleanup or dust-off work)
PCB boards **
a Regular cheap Binder (if its used even better, free stuff rocks!... make sure it still works tho)
2 Screws with their nuts (around 0.5" long)
Contact cement ***
a sheet of foam ***
a bunch of jump rings (small rings used mainly to make Charm Bracelets)
*necessary to cut foam and pry stuff off your PCB, anything that does this job will do
** as big as you can get em, for this project you will need at least 2 sheets (11.5 " x 10.25") and 1 (11.5" x 1") minimum
*** Optional but you may decide to use Them in the end (it protects the back of your notes and also gives a padded support)
I have been asked where did i get those huge PCB's here is my response: (if you know the name or kind of the equipment im talking about please comment, so others know where to look :)
Well im not sure what it was, there were 2 huge metallic boxes (the kind you put on a rack thing) On the front one reads " COGNEX 2000 vision systems" the other one reads "Turbo HR+ ESI vision products" on the back both have around 4 camera outputs and the second one also has some serial ports marked "SIO"
i found this picture of one of the PCB sources
i assumed they were some part of a closed circuit "surveillance system"... basically when they throw away stuff at the electronics department @ school they let us take what we want XD
UPDATE!!! googfan said he found some Server PCB's that are quite large, hope it helps
SAFETY FIRST! please! when using a cutting tool, or when you are prying things off your board wear eye protection, and cover your nose, i don't think PCB "sawdust" or solder fumes are good for your health, also i had a few close calls before i decided i HAD TO use the glasses