Step 4: Solder on
Wire up the diode and resistor as shown in image, make sure they are the right way around (the current only flows one way) before soldering by testing with a multimeter (I had photos on my laptop but my dog ate them), check voltage with multimeter. Put layers of shrink tube on to stop any wires from breaking. Solder on the plug, test and re-test.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
1
MediocreNinja
says:
Dec 15, 2010. 6:43 PMReply
Your dog ate photos on your laptop? How is that possible?
Visit Our Store »
Go Pro Today »
