Print PDF
Favorite
Email
Step 2Cutting
Once the pipe was marked out i clamped it to the bead of my wood lathe for cutting.
I used a jigsaw to make split the pipe into the 3 segments. each segment would make 2 blades so i would have 6 blades from this pipe.
Once the first cut is made rotate the pipe and clamp again, after the second cut a segment will be removed from the pipe. The pie then was able to be pushed down onto the lathe bead where it sat nice and steady for the final cut.
I used a jigsaw to make split the pipe into the 3 segments. each segment would make 2 blades so i would have 6 blades from this pipe.
Once the first cut is made rotate the pipe and clamp again, after the second cut a segment will be removed from the pipe. The pie then was able to be pushed down onto the lathe bead where it sat nice and steady for the final cut.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
