Print PDF
Favorite
Email
Step 3Mark & cut
With the hard ruler and the marker, mark a 1 inch (2.5 cm) strip on a side of the sheet of metal.
The ruler you see in the picture I made out of an aluminum bar taken from a 19inch rack of an electrical control panel. The markings were done with Autocad and printed on regular A3 paper. Glue and transparent protective plastic made the rest.
Now, if haven't done already, wear your safety goggles.
It is time to be precise. With the scissors (a regular but pretty strong pair) cut the strip along the line.
With the ruler and square angle ruler mark the lines where you will bend the strip.
The ruler you see in the picture I made out of an aluminum bar taken from a 19inch rack of an electrical control panel. The markings were done with Autocad and printed on regular A3 paper. Glue and transparent protective plastic made the rest.
Now, if haven't done already, wear your safety goggles.
It is time to be precise. With the scissors (a regular but pretty strong pair) cut the strip along the line.
With the ruler and square angle ruler mark the lines where you will bend the strip.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
