Introduction: Pallet Bed

Picture of Pallet Bed

I had to change the mattress of my bed and I wanted one hard enough. I thought I was going to use a pallet for that.

Step 1: Supplies :

Picture of Supplies :

- 4 large plates (for me " OSB1 " 67x205 cm)
- 1 pallet (for me 110x140 cm)
- 4 metal flat rods to keep the pallets
- 2 pieces of pallets to strengthen under the bed
- 4 feet
- screws

Step 2: Assemble the Wooden Plates

Picture of Assemble the Wooden Plates

Assemble the first two wooden plates and keep them with two flat rods screwed.
Then, screw the two small piece of pallet of 15 cm in the middle to strengthen all.
Weld the plates and the pallet below with screws.

Step 3: Feet

Picture of Feet

I bought pre- screwed feet. Drill four holes , where the pallet is the most solid. Holes smaller than the screw feet. Strengthen the attachment of the foot with hard glue

Step 4: Return the Pallet

Picture of Return the Pallet

return the pallet and assemble the two wooden plates with stems flat , right in the middle.
Screw more screws to assemble the plates and the pallet. Drill holes to ventilate the mattress. There you go ! 1h30 approximately

Comments

wold630 (author)2016-04-28

So simple and functional! Nicely done!

About This Instructable

483views

3favorites

License:

Bio: girl maker in Bordeaux
More by fcavalier:pallet bed
Add instructable to: