Instructables

Paper Clip Launch

Picture of Paper Clip Launch
 
Remove these adsRemove these ads by Signing Up

Step 1: Things You Will Need

Picture of Things You Will Need
13, 7:52 PM.jpg
1x paper clip

1x rubberband

Step 2: Preparing The Paperclip

Picture of Preparing The Paperclip
13, 7:52 PM.jpg
Point the paper lip so that two round loops are facing to the left. Next, bend the wire that is not inside up.

Step 3: Preparing The Paperclip Pt. 2

Picture of Preparing The Paperclip Pt. 2
13, 7:52 PM.jpg
Now, bend the top wire down. This creates a notch to slide the rubberband into.

Step 4: Finishing The Paperclip

Picture of Finishing The Paperclip
13, 7:52 PM.jpg
Bend the bottom inside wire 180 degrees to left, which makes our dart complete.

Step 5: Have Fun!!!

Picture of Have Fun!!!
Shoot it around and show it off to your friends.
achávez172 months ago

made a finger hole because the previous version was to thin

temp_-1323676710.jpg
nojack (author) 7 months ago
Yes, if it isn't too thick. Try corrugated cardboard.
snotty7 months ago
Will it stick into things like an arrow?
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!