Print PDF
Favorite
Email
Step 12Loop-the-loop
The first step in twisting and turning the strip when forming a 3D point, is the loop-the-loop. Notice how I hold the tip of the strip parallel to the base knot plane.
(Now that is a rather short strip end. I used strips with a length-to-width ratio of almost exactly 30:1. It makes the different actions fit nicely in my close-ups, but apart from that it is mostly a pain to work with too short strips.)
(Now that is a rather short strip end. I used strips with a length-to-width ratio of almost exactly 30:1. It makes the different actions fit nicely in my close-ups, but apart from that it is mostly a pain to work with too short strips.)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
