Step 6: Make some rockets
Print out and make plenty of copies of the attached PDF rocket template.
There are basic building instructions on the rocket template. Decorate and cut out areas as directed.
Roll the rocket body section onto forming tube, with the bottom of rocket (where the fin placement lines are located) just above the tape at the end of the forming tube. This creates an open space at the top of the tube, where the cotton balls will go.
Tape the body tube together, but NOT to the forming tube. Fold the fins and tape them in place on the fin placement lines. Place two cotton balls into the open area at the top of the paper tube, and cover with a couple of pieces of tape. Remove rocket from forming tube.
There are basic building instructions on the rocket template. Decorate and cut out areas as directed.
Roll the rocket body section onto forming tube, with the bottom of rocket (where the fin placement lines are located) just above the tape at the end of the forming tube. This creates an open space at the top of the tube, where the cotton balls will go.
Tape the body tube together, but NOT to the forming tube. Fold the fins and tape them in place on the fin placement lines. Place two cotton balls into the open area at the top of the paper tube, and cover with a couple of pieces of tape. Remove rocket from forming tube.
stomp rocket template.pdf(612x792) 222 KB
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
chrispix
says:
Jul 23, 2011. 1:29 PMReply
If you get "Super Jumbo" cotton balls, only one will fit in each rocket.
Visit Our Store »
Go Pro Today »
