Instructables
Very low cost folded paper container, for holding small items (such as screws) during repair, assembly, construction etc.

Can also be used as an envelope for carrying items securely.

It's disposable, recyclable, sustainable, environmentally friendly plus widely and freely available.
 
Remove these adsRemove these ads by Signing Up

Step 1: Making a paper square from a rectangular sheet

Take a rectangular sheet of paper. In America this could come from a legal pad, or in Europe an A4 notepad.

You are going to use basic paper folding techniques to crop it square.

Use your finger/thumb nails to form sharp, straight creases. If your nails are too short, use the edge of something like a credit card or a plastic ruler.

Step 2: First corner fold

Turn down the top right corner, aligning the short edge of the paper accurately with the left, long edge.


If you have made a paper aeroplane, or tried some basic Origami, this move should be famliar to you. Or you may be lucky enough to have some square paper already.

Step 3: Folding the waste piece

Open out the diagonal fold you have just made.

Turn up the bottom short edge to make a horizontal fold. This should be parallel to the top edge of the paper. A square will be created when this horizontal fold intersects the bottom right end of the first diagonal crease.

Step 4: Tear off a strip

Open out the paper, then remove the waste portion, leaving a square with only one crease in it, the diagonal one. Tear or cut, as you prefer. If tearing, don't worry about any slightly rough edges.

(If you were making a paper aeroplane, the piece you are now discarding would form its tail).

Step 5: Diamond shape

Rotate the square to form a diamong shape, with the single crease horizontal.

Step 6: Triangle

Lift the bottom point of the diamond up, to meet the top point.

Crease the centre fold sharply.

Step 7: Left side

Bring the left point of the triangle across to meet and stop at the right, sloping edge. Keep what was the lower left edge of the double skin of paper parallel to the base of the triangle.
1-40 of 58Next »
Puzzledd3 years ago
Great 'ible, thanks, with very clear and thorough instructions. .. and what good comments, too :)
peterbryenton (author)  Puzzledd3 years ago
Thank you.
Ninzerbean4 years ago
Very easy directions to follow though I am sure they were far from easy to write out. I was able to make my cup happily stand up just by folding the little points on the bottom inwards, though it will probably fall down if I put too much in to it. This is great and thank you for sharing.
peterbryenton (author)  Ninzerbean4 years ago
Thank you. Glad yours stood up on its points.

There are some useful suggestions amngst the comments about this 'ible.
josefu05 years ago
it like a cup.
peterbryenton (author)  josefu05 years ago
Yes, it's a paper cup too, thanks josefu0.
yokonga6 years ago
that's cool...
jukie6 years ago
I haven't read through all the comments so I don't know if these things have been mentioned, but I make these for my kids' snacks sometimes and don't have time to cut or tear off the bottom of the magazine page that I've used. So I just leave it attached (keep it folded up and just continue with the folding. Also, I don't use tape and it holds just fine.
peterbryenton (author)  jukie6 years ago
Thanks. Your snack sacks also sound like a good way to encourage young readers. Peter www.brypix.com
Mintyhippo6 years ago
i have been making these since 3 years ago! I was just about to post mine until i saw this. Mine has a cup holder, should i still post?
peterbryenton (author)  Mintyhippo6 years ago
Of course you should post. The great wonder of people is their different approaches to the same ideas. I look forward to seeing your version. Regards, Peter Bryenton www.brypix.com
thanks, and i will give you partial credit if you want.
Phoenix26026 years ago
These would be great for holding your dice at an RPG gaming session!
peterbryenton (author)  Phoenix26026 years ago
Especially if your character was a magician called Origami.
AdamK6 years ago
Great instructable. I tried printer paper when I did this, only to find that it leaked through the paper itself. I then discovered that I could filter sugar water (but not salt water) with my make-shift filtering cup. Could be a very useful application by chemists if they have the right type of paper. Or even to drain starch out of pasta? Haha
peterbryenton (author)  AdamK6 years ago
Shame about the salt water: I suddenly had a vision of a gigantic, eco-friendly ocean-based desalination plant.
mailkd76 years ago
I just made it, and I am eating Cheesz-Its Out of it right now. Good Instructable! Mmm.... Cheese...
peterbryenton (author)  mailkd76 years ago
Ah, the old calorie-free container with the calorie-loaded filling trick, eh?
blooper7 years ago
woo-hoo! let's hear it for silly paper hats!
Tomton blooper7 years ago
Seconded.
gnose7 years ago
if youre using it for drinking/food and the sheet you have is printed on one side: when you reach step 6 make sure the printed on side faces outwards. when youre done, the inside surface of the cup is blank :)
I HACK7 years ago
lol great idea thanks
Brilliant idea
Tried it at home went into the kitchen, i managed to refill it from tap 8 times, and after that the only damage was a small leak from the bottom, i can imagine this was only bec8ause the water from the tap was hitting it hard. 8 times refill from standardd white A4 paper. Genius.
peterbryenton (author)  lifelong-newbie7 years ago
Good, thanks. www.brypix.com
PVC marxman7 years ago
when Im thirsty in school i use these lol
peterbryenton (author)  PVC marxman7 years ago
Me too.
Cornflower7 years ago
Used the idea for years. Just to add to it, you can get away without the tape if you flip the right side (step 8) behind the cup, not over the left side, and then in steps 9 and 10 you can tuck the top flaps inside the right and left flaps with the whole thing holding together.

Another thing, I sometimes make a second one out of wax paper or tin foil if I need a drink of water, and put it inside the paper one. Kept the two in my back pocket when visiting another city a few years ago.
peterbryenton (author)  Cornflower7 years ago
Elegant solutions, thank you. Peter Bryenton www.brypix.com
you know, it wouldn't last too long, but that can also hold water. if you make it out of wax paper or something, it'd hold for a while. the only thing keeping it from holding it longer is whatever paper you use.
peterbryenton (author)  origamimavin7 years ago
Good suggestion, thanks.
WATER CAN GO IN THIS!!!!!!! no i'm serious..
Yes, the wax paper comment here is so much "greener" than plastic cups. Folds back flat again too, for re-use: sustainable!
gowithflo7 years ago
I think this would be great for starting seedlings in too, then just plant right in the soil. I'm going to try it.
peterbryenton (author)  gowithflo7 years ago
Thanks: yours is one of the most unusual suggestions I've heard about this in years. I'll tell my friends at the local college of horticulture what you said. Let me know how your seedlings turn out -- maybe some pictures too? Peter Bryenton www.brypix.com
Ben.land1017 years ago
cool
peterbryenton (author)  Ben.land1017 years ago
Thank you.
blindmen7 years ago
very good and usefull idea
peterbryenton (author)  blindmen7 years ago
Thank you.
lucashaley7 years ago
You can make these free-standing by folding the bottom corners into the middle. They then stand quite nicely. Great tutorial!
peterbryenton (author)  lucashaley7 years ago
Thank you. I'll have a go, then photograph & publish the result.
1-40 of 58Next »
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!