Introduction: Paradord Watch

Picture of Paradord Watch

Here is one of my latest bracelets.
(I took this picture after I made the bracelet)
What you will need:
x2 2.5ft paracord
Lighter
Plastic clasps
Watch
Scissors
Optional- Jig

Hope this Instructable is helpful. If you have any questions feel free to comment and I will try to get back to you as soon as possible.

Step 1: Step 1

Picture of Step 1

Take first section of 2.5ft paracord length and make a loop around the clasp by bringing both ends of the cord under and through the clasp, then take ends through the loop that was just made (See picture with pink cord) and pull tight

Step 2: Step 2

Picture of Step 2

Take the watch and feed one end of the cord up and into the gap and one end down into the gap of the watch. This will help transition into the weave. Pull tight and repeat on other side.

Step 3: Step 3

Picture of Step 3

Start Paracort weave (see my other instructable if you do not know how to perform this weave). Weave until done with that side, then repeat on other side until done.

Step 4: Step 4

Picture of Step 4

Once done with the weave and the clasp is flush with the end of the weave, cut end of the cord right up to the weave, this will be melted and pressed to the bracelet for clean and secure melt

Step 5: Step 5

Picture of Step 5

Repeat on other side, and you are done!

Comments

About This Instructable

3,020views

100favorites

License:

Bio: Fisherman, Kayaker, knife collector, outdoorsman. Living on a small farm in the Midwest
More by katofall00:Paradord WatchWhat To Put In A Fishing BagHow To Make A Paracord Lanyard
Add instructable to: