Introduction: Pen Gun

Picture of Pen Gun

Please leave a comment if you like it.

Step 1: The Materials

Picture of The Materials

1 1/2 pen tubes (non clickable),an ink cartridge, rubber band an a roll of duct tape.

Step 2: The Body

Picture of The Body

Take the 1 1/2 pen tube and a piece of duct tape and put the tubes together.

Step 3: The Rubber Band

Picture of The Rubber Band

Take the rubber band and wrap it around the tube.

Step 4: The Finish

Picture of The Finish

Take the ink cartridge and put it in the tube and you done.To fire take the bolt (ink cartridge) put the rubber band on the back of the bolt pull back and fire. And if any one get hurt by this it's not my fault.

Comments

inoname (author)2014-06-17

PEN KILLER you had made it good. But if any one want to check mine then you could go to

http://www.instrucables.com/id/pen-gun-15/

it fires gel pen ink cartrages upto 80 feats.

penKiller (author)2013-09-24

This is my first instructable so if I need to do anything better just tell me.

About This Instructable

788views

1favorite

License:

More by penKiller:Pen Gun
Add instructable to: