Introduction: Office Pen Launcher

Picture of Office Pen Launcher

Build a small pen ink launcher that can shoot up to 100 ft. You can shoot people at school and at the office but that's not very nice :)

Step 1: Materials

Picture of Materials

What you need is-

2 rubber bands
1 big paper mate pencil ( for the barrel)
Pen ink (Projectile)

Step 2: Take It Off

Picture of Take It Off

Take the front of the pencil off.

Step 3: Take the Back Off

Picture of Take the Back Off

Take the back of the pencil off with the Scissors.

Step 4: Take It All Out

Picture of Take It All Out

Take all of the parts in the pencil out.

Step 5: Place the Band On

Picture of Place the Band On

Place the rubber band on the end of the barrel.

Step 6: Tie a Band On

Picture of Tie a Band On

Tie the other rubber band by wrapping it on.

Step 7: Place the Pen Ink In

Picture of Place the Pen Ink In

Now it's finished. Time to go shoot.

Step 8: Cock It Back

Picture of Cock It Back

Pull the rubber band and the ink back with one hand while holding the barrel with another. Make sure the back of the pen ink is touching the rubber band.

Step 9: Let Go!

Picture of Let Go!

Let go and the rubber band will shoot the ink down the barrel and out toward the target. have fun making it :)


wold630 (author)2016-01-25

Wow! This would be fun for target shooting outside!

About This Instructable




Bio: Comment what I should make. I will try to make anything with what I have.
More by John_Singleton_:Airsoft Gun Coil Gun Airsoft Ammo Capacity HackDIY EDC Pen Spear
Add instructable to: