Introduction: Pimp'n Hovercraft

Picture of Pimp'n Hovercraft

This is how to make our extreamly fly craft that hovers.

Materials Needed
4 by 4 plywood (You can cut a 4 by 8 in half too)
Tarp
Lid
Buzz saw/ Jig saw
Staple Gun
Duck Tape
Leaf Blower
Extention Cord
Scisors

What did and didn't work
Everything want well exept when we made the holr for the leaf blower, We kept on making it to small.

Physics Concepts
The air resistance pushes the hover board up and also stops it along with friction lets just go with that.

Step 1: Step 1

Picture of Step 1

Gather Materials!

Blue Prints!

Step 2: Step 2

Picture of Step 2

Use buzz saw to cut plywood into a circle With a 4 ft. diameter.
Then cut a hole for the leaf blower.

Step 3: Step 3

Picture of Step 3

Use scisors to cut tarp into a circle With a 5 ft. diameter.
Cut 8 1 1/2 in. holes around the center of the tarp.

Step 4: Step 4

Picture of Step 4

Staple and tape tarp to the top of the plywood (leave enough space between the bottom of the plywood and the tarp)

Step 5:

Picture of

Get a lid from a coffe can or any kind of lid, and stape the lid from the of the the tarp to the plywood.

Step 6: HOVER!!!!!!!!

Place leaf blower into the hole on the plywood, and HOVER!!!

Comments

boog123 (author)2009-06-03

what kind of lid and that is cool

geoslim13 (author)boog1232010-02-20

a coffee can lid check this one out for more info www.instructables.com/id/Simple-Rideable-Hovercraft/

nedyah444 (author)2009-09-14

Awesome! I tried it myself and was amazed, so was every one I showed it to

jessicafromsheekgeek (author)2008-12-26

What type/model leaf blower did you use?

FRABBAfrabbaFRABBA (author)2008-12-23

what power is the leafblower?(watt)

explosivemaker (author)2008-12-20

you spelled extremely wrong

About This Instructable

18,934views

22favorites

License:

More by Flyingsquirel:Pimp'n Hovercraft
Add instructable to: