This is how to make our extreamly fly craft that hovers.
4 by 4 plywood (You can cut a 4 by 8 in half too)
Buzz saw/ Jig saw
What did and didn't work
Everything want well exept when we made the holr for the leaf blower, We kept on making it to small.
The air resistance pushes the hover board up and also stops it along with friction lets just go with that.
Step 1: Step 1
Step 2: Step 2
Use buzz saw to cut plywood into a circle With a 4 ft. diameter.
Then cut a hole for the leaf blower.
Step 3: Step 3
Use scisors to cut tarp into a circle With a 5 ft. diameter.
Cut 8 1 1/2 in. holes around the center of the tarp.
Step 4: Step 4
Staple and tape tarp to the top of the plywood (leave enough space between the bottom of the plywood and the tarp)
Get a lid from a coffe can or any kind of lid, and stape the lid from the of the the tarp to the plywood.
Step 6: HOVER!!!!!!!!
Place leaf blower into the hole on the plywood, and HOVER!!!