Print PDF
Favorite
Email
Step 3Route the 'Tracks'
Now it is time to route the 'tracks' into the top piece of wood.
This is how I set my router table.
(1) I used a 3/4" straight bit.
(2) I set the depth of the cut at about 1/8"
(3) I set the fence at about 5/8' from the center of the bit. Which will put the cut about 1/4" from the edge of the wood.
(4) After the initial 1/8" depth cut, I did a second cut at 1/4"
This is how I set my router table.
(1) I used a 3/4" straight bit.
(2) I set the depth of the cut at about 1/8"
(3) I set the fence at about 5/8' from the center of the bit. Which will put the cut about 1/4" from the edge of the wood.
(4) After the initial 1/8" depth cut, I did a second cut at 1/4"
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
