Plasma Cutter Creations

Published

Introduction: Plasma Cutter Creations

About: I am Matthew Enderle, and my instructables are based on electrical and computer sciences.

Hello I wanted to just get some of my plasma cuttings out there on the net. I bought a plasma cutter from my high school and it was my parent's anniversary on Oct. 12 and my mom's bday that same day. We live on an Elk Ranch so I made their gift an homemade elk head from 1/8" Steel. The Elk head took about two hours to make from sketching it on the metal to cutting it by hand. Once I get my Air Compressor's regulator fixed I will be making the design I made in Photoshop on the same metal. I will say I know that this unstructured story of this article is not well written because I worked all day and I will be doing a much better write-up/format when my next piece is done.

Share

    Recommendations

    • Creative Misuse Contest

      Creative Misuse Contest
    • Oil Contest

      Oil Contest
    • Water Contest

      Water Contest

    Discussions