Introduction: Play Music Using Arduino and Buzzer

In this video tutorial I will show you how to play music using arduino and piezo buzzer at end I will show you how to play jingle bell and Indian National Anthem using arduino.

Step 1: Step by Step Guide to Play Any Music Using Arduino

For this experiment, You need

1. Piezo buzzer

2. wire / Jumper cable

3. bread board

4. Arduino

Connect buzzer +ve to Arduino Digital pin, and -ve to ground of arduino.

Download the code from here:

Copy to arduino and upload the sketch.

Now you can hear, the audio.


About This Instructable




Bio: Blogger, Hacker, Embedded Product Designer :)
More by satyasankar09:ESP8266 OTA Tutorial - Over the Air UpdatePlay Music using Arduino and Buzzer Raspberry PI GPIO Control Using C
Add instructable to: