Introduction: Play Music Using Arduino and Buzzer

Picture of Play Music Using Arduino and Buzzer

In this video tutorial I will show you how to play music using arduino and piezo buzzer at end I will show you how to play jingle bell and Indian National Anthem using arduino.

Step 1: Step by Step Video Guide

For this experiment, You need

1. Piezo buzzer

2. wire / Jumper cable

3. bread board

4. Arduino

Connect buzzer +ve to Arduino Digital pin, and -ve to ground of arduino.Download the code from here: https://drive.google.com/open?id=0BxBxmZBpX9U9ZVBZcDRhWVNpQ2c

Copy to Arduino and upload the sketch.Now you can hear, the audio.

Youtube Channel : https://www.youtube.com/c/MyElectronicsLab

More Tutorial On : https://www.myelectronicslab.com/

Comments

About This Instructable

190views

7favorites

License:

Bio: Blogger, Hacker, Embedded Product Designer :)
More by satyasankar09:ESP8266 OTA Tutorial - Over the Air UpdatePlay Music using Arduino and Buzzer Raspberry PI GPIO Control Using C
Add instructable to: