This guide will show you how to build a playful puppy robot that can be programmed with the Arduino IDE. Sample code is provided that will let you control the robot with simple hand gestures to perform tricks such as shaking hands and walking on his back legs.
Remove these ads by
Signing UpStep 1: Materials
#1 Phillips Screwdriver
Hot glue gun, Optional
Needle Nose Pliers
Small Flathead Screwdriver
Quad Bot robot chassis
Pan / Tilt kit
IR Compound Eye
Magician Robot Controller
Jumper Wire Pack, female to female and male to male
Servo extension cable (4), Short - 100mm (4inches)
Cable ties (10+), Small
Li-Po battery pack, 7.4V (2 cell) 2300mAH
Spacers (2), 25mm (1 inch)
Spacers (4), 8mm (1/3 inch)
Hot glue gun, Optional
Needle Nose Pliers
Small Flathead Screwdriver
Quad Bot robot chassis
Pan / Tilt kit
IR Compound Eye
Magician Robot Controller
Jumper Wire Pack, female to female and male to male
Servo extension cable (4), Short - 100mm (4inches)
Cable ties (10+), Small
Li-Po battery pack, 7.4V (2 cell) 2300mAH
Spacers (2), 25mm (1 inch)
Spacers (4), 8mm (1/3 inch)
Visit Our Store »
Go Pro Today »
http://makeprojects.com/Project/Playful-Puppy-Robot/1375/1
Plagerism at its finest right here.