Playstation 2 Guitar Amp

Step 5 The Marriage of the PS2 and Amp

I had to make a quickie washer to get the input jack to tighten good enough. I put the input jack where the usb ports were on the ps2. I removed the LED in the middle then extended it with a piece of wire so it could light up in the front. I had to remove the middle piece of plastic so the board would fit in. It's very easy to see where to put the holes for the knobs with the grating in the front. You can go ahead and put all the knobs together and it will help keep the board in place.

The speaker is easy to lay out. Just mark for the screw holes (stupid me only had 2 screws that had nuts with them) then drill in a pattern for sound holes in between.