Print PDF
Favorite
Email
Step 11Epoxy!
Make very certain that your circuit is working. Check it and then check it twice. If it does not work, do not pass go and go back to Step 10.
Coat both side of your circuit in a generous coating of epoxy. Make sure that the cables are untangled and laying flat on the board while you do this.
This will help protect it when you stomp on it and also hold the connections in place and keep the board from shorting. Don't hesitate to add more than one coat. It should feel smooth all around after this.
Coat both side of your circuit in a generous coating of epoxy. Make sure that the cables are untangled and laying flat on the board while you do this.
This will help protect it when you stomp on it and also hold the connections in place and keep the board from shorting. Don't hesitate to add more than one coat. It should feel smooth all around after this.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
