Print PDF
Favorite
Email
Step 7Sensor Board
The illustration shows suggested wiring (note: I've used wire that is < 1.2mm so that it will pass through the holes in the board) you could alternatively widen the necessary holes with a drill.
Solder the IR sender and reciever in place. Also solder on the wires that will go down to the main board, and make a note of where the wires from the battery will be soldered later.
Solder the IR sender and reciever in place. Also solder on the wires that will go down to the main board, and make a note of where the wires from the battery will be soldered later.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
