Picture of Polymer Bar Pendant
poly bar2.jpg
poly bar3.jpg
This pendant is simple to make using only a few tools and a couple materials.

File divider
Polymer Clay
Drill & drill bit
Sand paper
Soldering paste
Silver solder
Heat source
Remove these adsRemove these ads by Signing Up

Step 1: Another use for a file divider

Cut out the strip to a file divider. Use a pair of pliers to bend the end at 90 degrees. Make sure the bend is squarely bent.

Move down the metal strip until you reach your desired length. Bend both ends down at 90 degrees until you have a rectangle. Cut the free end as flush as you can to the pendant.

Step 2: Solder and drill

Apply soldering pasted to the joint. Add a little piece of silver solder. Apply heat until it’s joined.

Place the rectangle back onto the pliers and use a punch to make a starting mark for the drill bit. Do this on both sides. Drill a hole and keep the drill bit handy.

Step 3: Polish

Picture of Polish
Wrap sand paper around a drill bit and spin it round. Use this improvised sander to polish the pendant. Use a buffing wheel to further polish.

Step 4: Fill and bake

Picture of Fill and bake
Fill the pendant with polymer clay. Place a plastic bag over the pendant and use a rolling pin to roll out the excess clay. Place the drill bit into the drilled hole while you fill it.

Bake the pendant following the instructions for the clay.
Londonbrig02 years ago
Love the look of this one, sort of modern. Does the clay bake to a shiny finish, or did you polish it more after baking?
And he does it again!
bioassist3 years ago
Inspired I am.
There is so much crap (material) that is thrown out where I work that I have pendants dancin' in my head.
Good pictures, to-the-point instructions.
Top Notch, Yo.
bpfh3 years ago
Nice 'ible. Very simple in practice, but kudos for getting the metalwork part done so easily, and for recylcing used things :)

Mrballeng (author)  bpfh3 years ago