Instructables
Picture of Pop Tab Bracelets
bracelet.jpg
Start raiding those recycling bins!
Turn aluminum can tabs into cool jewelry!
 
Remove these adsRemove these ads by Signing Up

Step 1: Gather your supplies

Picture of Gather your supplies
For starters, you need a pile of pop tabs. Somewhere between 20-26, depending on wrist size.
You also need elastic cord and scissors. That's it! No other supplies necessary.

Step 2: Start assembling

Picture of Start assembling
Cut cord to approximately 2-1/2 feet.
Loop through the first tab, situating the tab at center of cord.

Step 3: Another tab

Picture of Another tab
Hold another tab below your first tab, (make sure your rough edges are always facing each other, smooth side to the outside) overlapping so you can see through openings of both tabs.

Thread the cord up from the bottom through both tabs, bringing top cord through top hole and bottom cord through bottom hole.

Step 4: And another tab

Picture of and another tab
OK, now get another tab and hold it on top, overlapping as before,
and this time, thread the cords through the opposite holes forming an X on top.

Step 5: Keep going

Picture of Keep going
Another tab, held at the back and thread those cords through,
top cord-top hole, bottom cord-bottom hole.

Step 6: Don't give up

Picture of Don't give up
Another tab, held on top, thread cords through forming that X. Top cord-bottom hole, bottom cord-top hole.

Step 7: Almost done

Picture of Almost done
Picture 011.jpg
Keep going, repeating step five and step six, alternately,
until bracelet can be wrapped around your wrist and ends meet comfortably.
You need the last tab to be one placed at the back side.
Then, bring ends together and form final X.

Step 8: It's finally done!

Picture of It's finally done!
Tie the cords in a knot and trim the ends.

Step 9: Masterpiece!

Picture of Masterpiece!
Turn bracelet back over and slide it on your wrist.
There should be just enough stretch to easily go
over your hand and then be lightly snug on your wrist.

Step 10: Add personality.

Picture of Add personality.
There's plenty of ways to embellish these bracelets, too.
You can paint the tabs, use colored elastic, add beads,
anything you can think of.

Well, I hope my tutorial is clear
and you enjoy making your own pop tab bracelet.
1-40 of 110Next »
Karithina4 years ago
I was lucky enough to already have too many pop tabs lying around on a necklace I was using to hold my USB stick. So thanks to your guide I have a usb bracelet instead <3

I didn't have any elastic cord lying around but I did have four sets of broken earphones, I used one side of a split earphone cord and had plenty left over. It's a bit of a squeeze without it being elastic but I've left just enough space for it to not be uncomfortable and not too much for it to slip off.
It still needs some painting which I probably should have done before I made it but oh well!
002.JPG
i didn't have any elastic cord either but you inspired me to use my broken headphones, i didn't use this design though i used this one: http://www.instructables.com/id/Pop-top-braclet/
BrittanyC1 made it!5 days ago

It took me about an hour but it came out great. I didn't have enough tabs because I've just started to do this project since I saw them in the store for $5 and didn't want to spend money on something I could make myself, even a child can make it so why spend that much on something recycled when you can do it too! What I love about this project by ShaJen is that she makes it very easy to understand and with the images it makes it even more easy to not get lost. Thank you so much! My Mom loves it and she wants to make some, too.

Hope you like mine! : - )

<3

Snapshot_20140914_7.JPGSnapshot_20140914_11.JPGSnapshot_20140914_13.JPGSnapshot_20140914_6.JPG
andyputra4 months ago

couldnt find any soda can so i went through my parents garbage can and got enough tabs for like twenty of these things! http://jambhu.blogspot.com/

Savanniepoo5 months ago

Fabulous :)

Katie B5 months ago

I loved this idea, but it was too confusing. When I almost finished, the X's made the whole thing unravel into a big tangle. I had to cut the string to get the tabs free. Luckily I found another tutorial on how to do it without the X's. I don't know if anyone else had this problem, or if I just didn't understand the instructions... Well, thanks anyway.

koolbeanz1 year ago
make 1 all different colors plzzz
kat19992 years ago
i painted mine whith nail polish to make it extream colered
Calyie2 years ago
It took me 2 hours to make it but it was worth the time! I did it and it looks great! But the bad thing is I didn't color it before! Try it with Monster Energy or Red Bull
tops! It looks cooler and it has color!
anu375teck2 years ago
instead of cord you can use shoelaces or ribbon. i make these for my friends. it saves money and helps pass time
SarahKat5523 years ago
i have seen MANY people try and make directions on the pop tab brcelets but you explained it the BEST 2day alone i have made 4 of them 1 for my mom (she made me) 1 for coutney 1 for lora (my bffs) and lastly one 4 me thanks soo much and i think i am going to make matching earings (teehee) oh thanks again
Grr...Fear Me (thats my phone singature to)
What?

I can't understand you. Are you sure you can't move your fingers just a _little_ bit more, so that you actually type words instead of numbers? Or do you need typing lessons? I'm sure you can find typing games...

peaceupgg3 years ago
sorry they are not the best pic but i made mine reversable
Picture 21.jpgPicture 20.jpg
Do you have instruction for the reversable? That is a real cool idea.
Seriously?...

It's called a "reversible". You just invert the original bracelet. It won't have the X's from the elastic.

Good job!
ale-8-12 years ago
This was one of the first projects I did on this site. My friends loved them. Is there a way to cut down on the sharpness of the tabs? The strings got cut.
Sandpaper.

Since you probably don't have that, just use a strong emery board.
If you don't know what that is... It's a nail file.

If you do have sandpaper, cut a little piece, attach it to a craft stick using glue and file down the sharp edges. Good job.
zseymour2 years ago
Can I use yarn instead of elastic cord and will work just as well?
noo. the pop tabs just tear the yarn..
get the bead string from walmart :D
wer3g962 years ago
I loved doing this. I didn't have any elastic cord at the time, but I used a old shoe lace insted. not very colorful, (my lace was grey) but I still love it. I wound up recycling 2 things at once! Also, for those of you Twilight fans like myself, Kristen Stewart has a soda tab bracelet too! You can google it. I think Robert Pattinson made it for her? IDK, but anyway, amazing idea, I love mine!
cmalott2 years ago
How do you make it with two different colors? My little cousin made a pink and green bracelet and I never figured out how to do it..
kodiac2 years ago
oh and ive asked this alot and still havent gotten an answer. if monster tabs dont have holes in the tops how do you make the holes and also were do you get the elastic bands for these things cuz i want to make a bracelet for each arm and quite possibly a belt
cmalott kodiac2 years ago
You can findd the elastic bands at walmart in the sewing/craft section. they have different packs of different colors so make sure you get the colors you want (:
PepperDust5 years ago
AWESOME instructable! Just made a reversible one of these in pink and green. Quisk and easy with great results! Kudos.
Picture 27.png
did you color with marker, paint, or use already colored tabs for the colors?
Used pre-colored tabs I'd been saving for a while... from Monster and Go-Girl cans. =)

Maybe next time I'll use a sharpie!
well monster tabs dont have hole in the tops so do u just cut out. oh and also were do you get the elastic bands ive tried to find some but no luck
i used sharpie pen that worked
ShaJen (author)  shyamiko5 years ago
PepperDust used colored tabs. They can be painted...not sure if markers would work out. Also, you can use colored embossing powder. Thanks for the comments.
where'd you get the pink tabs?
Monster Energy Drinks =)
nice =) i didnt know they made pink ones
where did u get the purple pop tabs ?
Monster energy drinks have tabs in green, red, orange, and some other colors... Go-Girl has pink (which is what I used)... I have yet to find a good purple one. Most look like navy blue. But yeah, energy drinks. Check them out.
kodiac2 years ago
haha couldnt find any soda can so i went through my parents garbage can and got enough tabs for like twenty of these things!
myhightide2 years ago
This is really cool! You can also make anklets, necklaces, bookmarks, and I am currently working on a belt. I have decorative, bright rubber string that shows up great next to the silver. Red looks best. I also am trying to save monster tabs to make a green bracelet. By the way, I heard of a 10 year old who sold these at her swim meets, and she was so successful that some of the local stores started selling them too. Thanks for the awesome tutorial! :)
That is so cute, easy and COOL!
I made 2, a yellow and silver one for my neighbor who kindly donated lots of tabs. And a pink and silver one for me. BTW, thanks to the people with the monster tab hole-punching comments, helps a lot, 'cause I just realized about the one hole. :P And the images are from a video I found which wasn't as clear as these instructions. :) Now all I need to know is if it'll break my hole puncher...

... Hmmm...

~SDNT
alveena2 years ago
Do you have the collection bout the recycling of the pop tabs.
http://wwwanna889.blogspot.com
13.png
alveena2 years ago
where are the golden jewelry of the pop tabs.
http://wwwanna889.blogspot.com/
 You could Use Monster Energy Drink tabs for this 
Awesome Job
1-40 of 110Next »