Instructables
loading
loading
Picture of Pop top braclet
This instructable shows how to make a bracelet out of the thingys on top of soda cans.
 
Remove these adsRemove these ads by Signing Up

Step 1: Supplies

Picture of Supplies
IMG_4605.JPG
Get a lot of soda can tops. I'm 13 and I used 14 on this one. I used 17 on my other one so get 25 and you should be okay.

You also need string.

And scissors.

Step 2: Starting it

Picture of Starting it
IMG_4609.JPG
Put the loop through the top hole as shown in pic 1

Put the 2 ends through the loop as shown in pic 2

Step 3: First one (cont)

Picture of First one (cont)
go around the sides and down through the bigger hole.

Step 4: Piece two side one

Picture of Piece two side one
put the string down into the smaller hole, around the side to the top, and down through the big hole.

Step 5: Repeat on other side

Picture of Repeat on other side
IMG_4614.JPG
Repeat on other side, and pull tight.

Step 6: Lather, Rinse, Repeat

Picture of Lather, Rinse, Repeat
IMG_4618.JPG
IMG_4617.JPG
IMG_4619.JPG
Repeat steps 4 and 5 until desired length.

Step 7: End it

Picture of End it
IMG_4621.JPG
IMG_4622.JPG
once it's long enough,put the string down and throug as you would (pic 1)

tie a pretzel knot around the side of the pop top

Step 8: Cut & youre done!

Picture of Cut & youre done!
Cut off the exess and you are done.
Show off as much as you want.

Step 9: Doubling it.

Picture of doubling it.
I just finished doubling it and taking pics, so the 'ible will be up in a matter of days.
how do you get it off and on?
Linbee4 years ago
I wonder if you could use the stretchy elastic used in jewelry making. That way you wouldn't have to be so concerned about getting it on and off.
kool