Print PDF
Favorite
Email
Step 8Lid and Finishing Touches
Remember way back in Step 1, I mentioned that I should have cut the lid a bit deeper? Instead of being able to use the rest of my pink foam board, I had to purchase some 1/2" insulation for the lid. Cut insulation to size and secure to lid with spray glue.
The pink insulation ring was added to keep the lid from moving around and to allow the hoses room to extend up from the top of the keg. The weather-stripping is there to provide a good seal to the cooler.
For a finishing touch, I added aluminum tape to the top of the cooler to cover the insulation and keep water out. I also tried to be generous with the tape on the lid.
The pink insulation ring was added to keep the lid from moving around and to allow the hoses room to extend up from the top of the keg. The weather-stripping is there to provide a good seal to the cooler.
For a finishing touch, I added aluminum tape to the top of the cooler to cover the insulation and keep water out. I also tried to be generous with the tape on the lid.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
