Step 1: Materials
[http://cgi.ebay.com/ME-PB-103RAWD-3-x2-wireless-circuit-prototype-PCB-board_W0QQitemZ310090266685QQihZ021QQcategoryZ36327QQtcZphotoQQcmdZViewItemQQ_trksidZp1742.m153.l1262) MeasureExplorer 3" Protoboard or smaller]
Breakaway Female Header, cut to size, or something similar from an old board you have laying around.
RadioShack Battery Box
Solder and Soldering gun
Double Sided Sticky pads
Step 2: Layout
After making your scratched lines, use a continuity tester to check and make sure the rows are not still connected to one another or the rest of the board. Each row should still have a connection to the holes in it.
Step 3: Solder Components
After your headers are soldered on, add the remaining components.
As mentioned earlier, the open holes at the top will allow you to jump power and ground to the open area for breadboard production at a later time when you need.
Step 4: Mounting to Battery Pack
Step 5: Test and Use
Hope you enjoy.