Print PDF
Favorite
Email
Step 2My parts and tools
My Parts:
Aluminum flashing: 15.75" x 2.5"
aluminum angle 1/16"x1/2"x3/4" length 2.5" (x3)
items to attach legs to screen: see "Attaching Legs"
Tools:
scissors / tin snips = to cut aluminum flashing
ruler / tape measure = to determine measurements
marking pen = to mark cuts
nail / center punch = to make starter holes for drill bits
drill & drill bits = to drill holes
screw driver = to attach legs to flashing
hack saw = to cut aluminum angle
file = to remove burr edges
utility knife = to cut slots
[Warning:]
[Working with metal can be dangerous. Cutting, drilling, grinding, and assembling metal can produce sharp edges, flying metal bits, and metal dust. Use proper eye wear, mask and gloves to protect against injury. Knowledge of the proper use of tools is also protection against injury. The following instructions is only to provide a demonstration of how I constructed my pot stand-windscreen. Your results may vary.]
Aluminum flashing: 15.75" x 2.5"
aluminum angle 1/16"x1/2"x3/4" length 2.5" (x3)
items to attach legs to screen: see "Attaching Legs"
Tools:
scissors / tin snips = to cut aluminum flashing
ruler / tape measure = to determine measurements
marking pen = to mark cuts
nail / center punch = to make starter holes for drill bits
drill & drill bits = to drill holes
screw driver = to attach legs to flashing
hack saw = to cut aluminum angle
file = to remove burr edges
utility knife = to cut slots
[Warning:]
[Working with metal can be dangerous. Cutting, drilling, grinding, and assembling metal can produce sharp edges, flying metal bits, and metal dust. Use proper eye wear, mask and gloves to protect against injury. Knowledge of the proper use of tools is also protection against injury. The following instructions is only to provide a demonstration of how I constructed my pot stand-windscreen. Your results may vary.]
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
