Print PDF
Favorite
Email
Step 7The Spring
The spring is used to push the lever back to the starting position after it has been depressed.
I started by cutting a small piece of re-bar and putting a hole in it. This will go in between the two towers of the back block and the wire will go through the hole. Then, I got a small spring and slid it over the re-bar.
Now the whole thing is ready to together and in the shoe.
I started by cutting a small piece of re-bar and putting a hole in it. This will go in between the two towers of the back block and the wire will go through the hole. Then, I got a small spring and slid it over the re-bar.
Now the whole thing is ready to together and in the shoe.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
