Print PDF
Favorite
Email
Step 13Add Connectors to the Sensor and Button Wires
Cut the ribbon cables and wires from the Control Pad Board to size now. You should be able to get a decent idea of how long they need to be now. Consult the photos if needed. Don't make them too long or the inside of the housing will end up crowded. Don't make them too short or you'll have to cut new ones!
Don't cut the wires from the main wrist-palm bundle any shorter than they are already.
Insert the wires for each of the headers into appropriately-sized Berg connectors using a crimp tool and (optionally) solder. I grouped mine as follows (see photos as well):
Side 1 (Control Pad):
GND
Up, Down, Left, Right
B, A, Start, Select
Side 2 (Main Palm-Wrist Wire Bundle):
Black, [space], Red, Lt. Blue
Dk. Blue, Green, Yellow
Peach, White
Don't cut the wires from the main wrist-palm bundle any shorter than they are already.
Insert the wires for each of the headers into appropriately-sized Berg connectors using a crimp tool and (optionally) solder. I grouped mine as follows (see photos as well):
Side 1 (Control Pad):
GND
Up, Down, Left, Right
B, A, Start, Select
Side 2 (Main Palm-Wrist Wire Bundle):
Black, [space], Red, Lt. Blue
Dk. Blue, Green, Yellow
Peach, White
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
