Print PDF
Favorite
Email
Step 15Connect the Sensors and Buttons to the Arduino
Place the bottom of the wrist housing back on the wrist of the glove. Connect the sensors via the main wire bundle, clipping the Berg connectors into place. Connect the Control Pad buttons using their Berg connectors on the other side of the Arduino.
Test-fit the pieces of the wrist housing together. It will be a tight fit, but everything should fit into place. If it doesn't, re-tinker the connector placements and cable routing until it does.
Test-fit the pieces of the wrist housing together. It will be a tight fit, but everything should fit into place. If it doesn't, re-tinker the connector placements and cable routing until it does.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
