Print PDF
Favorite
Email
Step 3Start hacking the phone...
First you have to open the phone... Use the proper screwdriver be very careful and patient.
You have to find the vibrating motor and remove it, we don't need it. It's something resembling a third of a plug, and usually has two terminals and on it's shaft some small iron piece. By rotating that small iron piece, it produces vibrations. You have to test it to see if it vibrates and also to discover it's polarity. You can do this by powering it up from a 1.5v battery.
On the phone's plastic case you have to pierce a hole somewhere near the location of the vibrating motor.
After you identified the + and - terminals, you have to solder on each corresponding contact on phone some thin insulated wire. I choosed black for -and red for +. make a small knot on the wires, close to the solderings and the other ends pass them to the previous pierced hole. O the other end of the wires, you will solder the miniature socket.
Now put the phone back all together, and proceed to the next step!
You have to find the vibrating motor and remove it, we don't need it. It's something resembling a third of a plug, and usually has two terminals and on it's shaft some small iron piece. By rotating that small iron piece, it produces vibrations. You have to test it to see if it vibrates and also to discover it's polarity. You can do this by powering it up from a 1.5v battery.
On the phone's plastic case you have to pierce a hole somewhere near the location of the vibrating motor.
After you identified the + and - terminals, you have to solder on each corresponding contact on phone some thin insulated wire. I choosed black for -and red for +. make a small knot on the wires, close to the solderings and the other ends pass them to the previous pierced hole. O the other end of the wires, you will solder the miniature socket.
Now put the phone back all together, and proceed to the next step!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
