WARNING : The possession and/or manufacture of nunchaku is illegal in many states all over the world.
in most cases you can possess them only for training purposes as part of a martial arts club.
Please check the laws regarding nunchaku in your local area BEFORE making these.
These have been made with 2 x 5 metre lengths of 550 paracord and 2 x 16mm diameter, 25cm long timber dowel rods.
You can vary the lengths/thicknesses of the rods to suit your needs.
You could even use some solid foam cylinders instead of the timber, to make them even softer - however, they would still be considered nunchaka by law - even foam ones.
There are only two knots used in the construction of these nunchaku, a solomon (or cobra) knot and a diamond (or lanyard) knot.
Detailed videos for making these knots are available on you tube, however, I have provided some simple photos of each stage.
Step 1: Tie a Diamond Knot to Start
Steps are shown for tying the diamond knot. if these aren't clear enough, search you tube for "diamond knot" for video instructions.
You will be tying four of these knots in the construction of this piece.
Layout the knot as shown and then slowly work the knot into a ball shape, continue until the knot is firm.
Step 2: Tie a solomon knot around the timber.
This is easier if you lay the timber on the floor and lay out the knot as shown until you get a few turns of the solomon knot onto the timber to hold it in place.
Once you have a few turns in place, the timber will be held firmly.
Continue tying the knot, pulling each turn as firmly as possible, until you reach the end of the dowel.